Will this ScanGaude work with a 2010 Damon Avanti with the Maxxforce5 4.5L V6 Diesel in a 2009 Workhourse w18 chassis. Thanks for ypur help

( Tom McNay, 11/26/2015 )

I would be more inclined to think the ScanGaugeII would be the appropriate unit for your vehicle. You will need to check to see if you have an OBDII port (trapezoid shape) near your steering column. If there is none then look for a round 6 or 9-pin connector.

with this work with a 2010 freightliner rv coach with cummins 360?

( rich, 11/20/2015 )

Rich,

Yes it is compatible with that vehicle.

Will this work for a 1993 Cummins 8.3litre on a Spartan chassis?

( Stanley Nowiki, 10/21/2015 )

Stanley,

The ScanGaugeD will work on vehicles dating back to around 1987 but you would want to verify that it has a round 6-pin connector up near the dash so that you would be able to plug in and monitor.

Please advise if this unit will work on my 1999 Fleetwood Discovery 34Q ( 5.9 Cummins / Allison Trans ) If required I can send VIN at later date due to currently out of town, Thanks

( Glenn Scott, 07/29/2015 )

Glenn,

Yes that would communicate with your vehicle. The only caveat is that you must have the round diagnostic port located up front near the steering column. Some of the earlier models only had the port back at the engine, so just verify that.