Mine is a 2005 32v and the wipers are operating but if I try and used the washer it blows t5bhe fuse could this be my issue? ( Richard Seabaugh, 05/15/2023 )

I don't think the issue is with this module, as it's job is to control the intermittent function of the wiper system, not the washer.

wipers work when they want to. Have to turn off the motor to restart wipers. replaced controller previously with W0007967/D.C. 5, 336 Model 1312/ Not sure this is correct model. Please advise. ( John C Peters, 03/09/2023 )

Hi John,

Based on your VIN that is the correct wiper module. I do not see an order for one in your order history, are you sure it was replaced before? If it was replaced before, then I would say your motor is probably pulling too many amps through the module and damaging it. I would highly recommend replacing the motor as well when you install a new module. When you place an order for the replacement module make sure you add the breaker to the order to prevent this from damaging it again. Here is a link to the product page W0007967-Kit with both the module and the breaker.

2003 Bounder P32 windshield washer doesn’t work. I have jumped the pump motor and it works ( Shannon Johnson, 02/01/2023 )

If you have a P32 the wiper control module would be part # 15598496

That being said, I believe the 2003 Bounder's were on W22 chassis, so if you could supply your VIN we can verify that for you.

Sure Power model 1312. Looking for explanation of what each connector is intended to do. There are six wires in a L pattern looking at connector. If I call the top of the L terminal #1 down to term #5, then over right to term #6, I have #1 unknown, #2 sprays fluid, #3 sprays fluid, #4 activates wipers, #5 12v in, #6 variable V for intermittent. What's diff bet. #2 & #3? What is function of #1? In my setup it's going to a shift interlock solenoid. Trying to figure out if it's working properly or needs replacement. ( David, 09/16/2022 )

Hi David, What are the last 8 Digits of your VIN?

the other day the cab of my rv filled with smoke and after the smoke cleared the wipers didn't work... I discovered the wiper control module had caught fire. I can't tell what the P/N is, it appears to be W0000334/ AC 2003 and model 1311. Will this part work? it looks very similar 2002 Fleetwood Pace arrow Workhorse chassis. Also, where can I get the plug that would insert into the module? Thank you for your help ( Bradley, 10/17/2021 )

Hi Bradley , can you email us your chassis VIN and we can verify part # and determine the correct plug also , help@workhorseparts.com